MIL-PRF-3043C
SOCIETY OF AUTOMOTIVE ENGINEERS (SAE)
SAE AMS 1546
Compound, Carbon Removing, Orthodichlorobenzene
for Engine Parts (DoD adopted)
SAE AMS 4377
Sheet and Plate, Magnesium Alloy 3.0A1 - 1.0Zn - 0.20Mn
(AZ31B - H24) Cold Rolled, Partially Annealed (DoD adopted)
SAE AMS 5046
Sheet, Strip, and Plate, Carbon Steel (SAE 1020 and 1025)
(Annealed) (DoD adopted)
(Application for copies should be addressed to SAE International, 400 Commonwealth Drive,
Warrendale, PA 15096-0001.)
2.4 Order of precedence. In the event of a conflict between the text of this document and the references
cited herein, the text of this document takes precedence. Nothing in this document, however, supersedes
applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1. Qualification. The resin coating furnished under this specification shall be authorized by the
qualifying activity before contract award.
3.2 Material. The base material shall be a thermosetting resin, free from drying and non-drying oils and
cellulose.
3.2.1 Recycled, recovered, or environmentally preferable materials. Recycled, recovered, or
environmentally preferable materials should be used to the maximum extent possible provided that the
material meets or exceeds the operational and maintenance requirements, and promotes economically
advantageous life cycle costs.
3.3 Toxicity. The material shall have no adverse effect on the health of personnel when used for its
intended purpose. The material shall not contain any hazardous compound as defined in FED-STD-313,
nor shall it contain any chemical listed in the current report of known carcinogens of the National
Toxicology Program (see 4.3).
3.4 Color. The material shall be blue when sprayed onto metallic surfaces. After the baking period, the
coating shall exhibit a green transparent coloration so that the metal surface underneath the film will be
clearly discernible (see 4.4).
3.5 Solids content. The solids content of the coating as furnished shall be 25 to 30 percent by weight (see
4.5).
3.6 Viscosity. The viscosity shall be 0.4 poise or less at 77oF ±2oF (see 4.6).
3.7 Photochemical requirements. The manufacturer shall certify that materials used in the adhesive are
non-photochemical reactive (see 4.2).
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business