MIL-DTL-82633A (OS)
a. Sample for first article inspection
b. Compound, Polymeric Elastomer, Thermosetting
c. Components A and B
d. Name and address of manufacturer
e. Location and identity of the plant which produced the samples
f. Manufacturer's identification
g. Date of manufacture
h. Submitted by (name), (date), for first article tests in accordance with the requirements of
MIL-DTL-82633.
4.3 Conformance inspection. For each inspection lot of compound submitted for acceptance, the
conformance inspection shall consist of an examination for acceptability of quality control methods used
by the manufacturer, an examination of filled containers for conformance to packaging, packing, and
marking requirements, and examinations and tests of samples for the requirements of 3.1.2 through 3.3.2,
of this specification.
4.3.1 Conformance samples. The conformance samples shall consist of a sample for tests and a
sample for examination of filled containers. The sample for test shall be labeled with complete
information on each component designation, on the lot and batch number, date of sampling, contract
number, and applicable specification.
4.3.1.1 Inspection lot. An inspection lot shall consist of the same type polymeric compound
produced by one manufacturer, at one plant, from the same materials, and under essentially the same
manufacturing conditions.
4.3.1.2 Sample for tests. A 2-gal sample of each component shall be taken at random from each lot
in accordance with ASTM D 140 and subjected to tests of 4.4. Unless otherwise specified, the values
specified in section 3 apply to the average of the results obtained from duplicate determinations for each
particular test. The lot shall be unacceptable if a sample fails to meet all requirements of this
specification except as noted in 4.3.
4.3.1.3 Sample for examination of filled containers. A random sample of filled containers shall be
selected from each lot of compound in accordance with MIL-STD-1916, verification level II and
examined for fill, closure and damaged or leaking container, improper container, and marking. The
sample containers shall be shipped as part of the lot if the lot is accepted.
4.3.1.4 Workmanship. Conformance of the compound to the requirement for workmanship and any
other requirements not covered by specific tests shall be determined by appropriate visual examination.
4.4 Test methods.
4.4.1 Specific gravity. Determine the specific gravity for both component A and component B by
the pycnometer method for roads, oils, and tars described in ASTM D 70.
5
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business