MIL-DTL-85054D(AS)
3.6.2 Rear face identification. The rear face identification shall be as follows:
USES
This material will displace salt water and moisture leaving a clear, corrosion preventive film. It
is intended for use on unpainted areas of metals, where the paint has cracked or been damaged
such as around fasteners, seams, and access panels. It is not intended for use on moving parts
that require a lubricated surface.
Instructions - For best results:
1. Wipe off dirt and excess moisture from surface to be protected prior to
applying the corrosion preventive compound.
2.
Apply a thin uniform coat of corrosion preventive compound directly on
area to be protected.
3.
Allow to dry for one half hour.
4.
Apply a second uniform coat of corrosion preventive compound.
NOTES: Application by wiping is not recommended. Reapplication of compound is necessary
after solvent cleaning or where coating has been damaged by abrasion. Types I and II (high VOC
compounds) may be removed by spraying with fresh compound and immediately wiping off.
Types IA and IIA (low VOC compounds) may be removed by wiping with isopropyl alcohol per
TT-I-735.
WARNING - CONTENTS FLAMMABLE
CAUTION (for spray cans)
Contents pressurized. Do not puncture, incinerate or store above 120 °F (48 °C). Do not place
can near open flame or other heat source. Use with adequate ventilation and avoid breathing
spray. Harmful if swallowed. Shake before using.
3.7 Workmanship. The workmanship shall be in accordance with the best commercial
practice covering this type of material. The coating shall be homogeneous and when sprayed,
shall yield a smooth uniform film. The ingredients shall be uniformly processed to produce the
quality of compound established by this specification. The finished product shall be clean and
uniform and free of any defects that might impair its use, such as sediment, metal or other foreign
particles in the self-pressurized containers, eduction tubes, and valve assemblies. The exterior
orifice of the self-pressurized containers shall be symmetrical and free of ragged edges and if
drilled, shall be symmetrical and in direct alignment with angle of discharge.
8
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business